Which model guitar goes in my case?

clearblue · Post by **clearblue** » Sun Mar 04, 2012 5:32 pm

I bought a vintage reissue case from a forum member fro a 350 Liverpool. The case was too narrow for it so i tried a 350v63. It fit but was a tight fit and the lid had to have a little pressure on it to close. I then realized this case was not for a 350. I compared it to the case my 350v63 came in and it was thinner and taller. I figured it would fit my 620 or 650c. It's definable long enough but not wide enough. I didn't want to try cramming any guitars in there. Now I'm wondering which guitar this case is for.

libratune · Post by **libratune** » Sun Mar 04, 2012 5:40 pm

Dan -- Measurements of inside length and width and outside depth (thickness) would help with the ID.

clearblue · Post by **clearblue** » Sun Mar 04, 2012 5:56 pm

The cutout for the guitar inside the case is 39.25 x 12.5 inches.
The outside case dimensions are 41.25 x 15 x 4 inches

kiramdear · Post by **kiramdear** » Mon Mar 05, 2012 4:06 am

Could it be for a 430 or a 2xx series model?

sloop_john_b · Post by **sloop_john_b** » Mon Mar 05, 2012 11:17 am

kiramdear wrote:Could it be for a 430 or a 2xx series model?

Dan said it's a vintage reissue case (silver I assume) so that couldn't be right.

Edit: Unless they made VERY few that would fit a 220/260 at the end of the run. Those probably lasted until '96 and the vintage cases started around '94...

clearblue · Post by **clearblue** » Mon Mar 05, 2012 11:39 am

Yes, the case is silver.

Rickresource Rickenbacker Forum

Which model guitar goes in my case?

Which model guitar goes in my case?

Re: Which model guitar goes in my case?

Re: Which model guitar goes in my case?

Re: Which model guitar goes in my case?

Re: Which model guitar goes in my case?

Re: Which model guitar goes in my case?