I may be in a lot of trouble,,hah!

Vintage, Modern, V & C Series, Signature & Special Editions

Moderators: rickenbrother, ajish4

Post Reply
User avatar
kenposurf
RRF Consultant
Posts: 3001
Joined: Thu Mar 10, 2005 11:50 am
Contact:

I may be in a lot of trouble,,hah!

Post by kenposurf »

Pulled the trigger..ouch had to pay tax of $175 and seller sez it may need a neck reset PAUL!!
http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... 0863626540
User avatar
jingle_jangle
RRF Moderator
Posts: 22679
Joined: Wed Dec 22, 2004 6:00 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by jingle_jangle »

No problem.
User avatar
kenposurf
RRF Consultant
Posts: 3001
Joined: Thu Mar 10, 2005 11:50 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by kenposurf »

jingle_jangle wrote:No problem.
Have I told you lately that I love you?
User avatar
danm
Junior Member
Posts: 130
Joined: Sat Feb 03, 2007 6:50 pm
Contact:

Re: I may be in a lot of trouble,,hah!

Post by danm »

Good deal!
User avatar
jingle_jangle
RRF Moderator
Posts: 22679
Joined: Wed Dec 22, 2004 6:00 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by jingle_jangle »

The seller's quote of $500.00 to reset the neck is, erm, on the optimistic side to say the least, though.

So, I guess that might be a problem... :(
User avatar
kenposurf
RRF Consultant
Posts: 3001
Joined: Thu Mar 10, 2005 11:50 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by kenposurf »

jingle_jangle wrote:The seller's quote of $500.00 to reset the neck is, erm, on the optimistic side to say the least, though.

So, I guess that might be a problem... :(
Doh...maybe reset the body instead!
User avatar
jingle_jangle
RRF Moderator
Posts: 22679
Joined: Wed Dec 22, 2004 6:00 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by jingle_jangle »

This is a DIY proposition. Hold the guitar like a baseball bat, by the neck, at approximately the fifth fret, with the top of the body in direction of swing.

Have somebody slow-pitch a well-used 12" regulation softball, slightly outside. Ideally, you want to address the ball (Hello, Ball!!!) at the R tailpiece. Swing for the bleachers.

This will undo decades of Pyramid strings, in one fell swoop.
User avatar
kenposurf
RRF Consultant
Posts: 3001
Joined: Thu Mar 10, 2005 11:50 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by kenposurf »

jingle_jangle wrote:This is a DIY proposition. Hold the guitar like a baseball bat, by the neck, at approximately the fifth fret, with the top of the body in direction of swing.

Have somebody slow-pitch a well-used 12" regulation softball, slightly outside. Ideally, you want to address the ball (Hello, Ball!!!) at the R tailpiece. Swing for the bleachers.

This will undo decades of Pyramid strings, in one fell swoop.
There ya go..on a serious :-) note..are Pyamids a problem? I have a set of 12 strings of theirs..and use the 11 guage on my six strings
User avatar
collin
Senior Member
Posts: 6992
Joined: Wed Mar 21, 2007 6:28 pm

Re: I may be in a lot of trouble,,hah!

Post by collin »

Congrats George - even with a bad neck angle, that's not a bad price. You can have it "made right" again and still have significant change left compared to a pristine example.
User avatar
kenposurf
RRF Consultant
Posts: 3001
Joined: Thu Mar 10, 2005 11:50 am
Contact:

Re: I may be in a lot of trouble,,hah!

Post by kenposurf »

More info on an online site,,yikes!
Always make sure the "neck set" on any Rickenbacker is good. That is, with the playing action set LOW, there should still be at least 1/16" to 1/4" left for the bridge to go lower. If the bridge is down all the way, or the top was routed to recess the bridge (to make it go lower), avoid that Rick! There is no "easy" way to fix this problem; the whole back of the guitar will need to be removed to reset the neck angle. No cheap or easy task (the cost of the repair could be more than the cost of the guitar!). The 1958 Rick 345 pictured here has about 1/8" left to go down, which is fine. Note the "toaster" style pickup.
Post Reply

Return to “Rickenbacker Guitars: by John Simmons”