Screws for 4003 Neck Pickup

[admin]

Hello everyone. I am looking for the size of the screws for the high gain neck pickup of my 4003. Any ideas. There is no way I can find them in the stores in my city. I don't think I can face another big box store.

Would the following be correct?

05302 Height Adj Screw 4-40 x 1/2" Cap Hex
06114 Height Adj Spring 5/32" o.d. X 1/4" length

[johnallg]

Peter, you do not need a spring for the neck, you need a rubber grommet. That screw is not the right one, it should be phillips head. The 4003.pdf file shows part 05203 but that is a wood screw, so that isn't right either. I looked at all the screws offered but I'm not positive of the threading and length. Sorry I can't be of more help.

[LostCoyote]

Hiya Peter, hiya John...it's such a simple and (seemingly) common little screw that I would have thought I'd have a few of them laying around. I took one off my 2009 4003 to be sure. And I don't have any laying around, or I would just mail you one. Sorry about that.
But as you can see; It's a 4-40 alright, and the threaded part is 1/2" long, with a #1 phillips head. Hope this helps.

[johnallg]

4003-neck-pu-screw2.jpg

4003-neck-pu-screw1.jpg

I took one off my 2009 4003 to be sure.
It's a 4-40 alright, and the threaded part is 1/2" long, with a #1 phillips head.

That would be it. Thanks George!

[LostCoyote]

You are more than welcome, and it gave me something to do as well.

[admin]

Yes thanks George. The problem for me locally is finding the right thread. Yes and thanks for the grommet detail, John! I appreciate you both taking the time to provide this information. Not a straightforward question it would seem.

[LostCoyote]

I will send you a PM, Peter.

[admin]

George your PM was most welcomed. I thank you for taking the time to help. I have, however, a couple of screws on the way. Thanks for the wonderful spirit.

[ram]

you just gotta love this forum!