I'm sure this has been covered before but I just can't find it...but is the bushing diameter the same on both headstocks? Or would I have to drill larger or dowel it and re drill smaller?
Thanks Joe
Will 4001C64 keywinds fit 4001V63 ?
Moderators: rickenbrother, ajish4
-
FabGearHead
- Junior Member
- Posts: 153
- Joined: Thu Feb 26, 2009 10:59 pm
Re: Will 4001C64 keywinds fit 4001V63 ?
Joe, the Schaller made standard bushing has a larger diameter, therefore the hole is slightly larger in the V63 headstock. The Gotoh made Kluson replica tuners as used on the C64 basses will have the smaller vintage size diameter bushing. You will have to modify the larger holes to fit the C64 size bushings.
Jim
Jim
Re: Will 4001C64 keywinds fit 4001V63 ?
Right on...thanks Jim!FabGearHead wrote:Joe, the Schaller made standard bushing has a larger diameter, therefore the hole is slightly larger in the V63 headstock. The Gotoh made Kluson replica tuners as used on the C64 basses will have the smaller vintage size diameter bushing. You will have to modify the larger holes to fit the C64 size bushings.
Jim
Re: Will 4001C64 keywinds fit 4001V63 ?
I just improvised...I stripped the chrome off the schallers and left just the nickel and lathed the bushing down a bit to make it thinner. It's not quite as small as the c64 but it looks a lot better.
-
FabGearHead
- Junior Member
- Posts: 153
- Joined: Thu Feb 26, 2009 10:59 pm
Re: Will 4001C64 keywinds fit 4001V63 ?
Great solution! I love good improvising, that's what makes things happen...
Jim
Jim
Re: Will 4001C64 keywinds fit 4001V63 ?
Nice. 
Just curios, how did you strip the chrome off?
Just curios, how did you strip the chrome off?