Check these out.

[johnhall]

Something like these?



Been there, done that. Anyway, nice looking designs there, Andy.

[admin]

Maybe John Hall will catch a glimpse and contact me?

Andy: Very nice designs. I imagine that it would require permission from Mr. Hall given the RIC trademarks.

[arondeau]

John,
yes, like those. I made those...ummmm, maybe 15 yrs ago? Could have been longer than that looking at the pens. Those are 12kt pens (no longer made), and the Ric emblem has since been purged from our inventory. Would you guys consider updating your tooling and offer these to us Ric customers? I can put together a presentation for you. And, yes, I am very aware of trademarks. I have been doing customization for this company for almost 28 yrs now. Your pens look a little beat anyhow. Time for new ones!

Andy

[paul_yan]

Amen!


Very nice designs, Andy. Like the black one a lot.
I would love the one on the right if the "R" was 50% bigger, rotated 90 degrees to the right, and located at the tip of the clip instead of the base.
How about shaping the clips as RIC guitar and bass headstocks+necks?

And how about "finishing" the pens in RIC gloss colours like FG, JG, MG, MN Blue, BBR, Trans Blue, Red and Green? (Except the "Rickenbacker" "RIC" and "R" which should remain gold or chrome.}

[ken_j]

I'd like the black one with the "R" tailpiece added to it. They all look good though.

[mortivan]

I'd love one like the black one with the full name engraved on the barrel. I'd even pay full price for it!

Nice work Andy.

[wmthor]

Although I'd take any of the above if offered, I would prefer the "R" tailpiece on the center pen.

[beatlefan]

I really like #'s 1 and 3 the best....

However, I'd like the middle one if the logo was turned parallel with the clip. I can see that logo getting snapped off, or gouging into a body part.....