Page 8 of 8

Re: Repairing A Chip

Posted: Sat May 23, 2009 9:33 pm
by jps
rickenbrother wrote:One small heads-up that I should have mentioned early in this thread. If you want to mix different color nail polishes to make the best possible color match, DO NOT use plastic bottles/containers! The nail polish will usually eat right through the plastic. It might not be right away either. You might find a nasty mess a few days later. Use glass bottles.
Didn't Diane warn you? :lol:

Re: Repairing A Chip

Posted: Sun May 24, 2009 12:44 am
by rickenbrother
jps wrote:
rickenbrother wrote:One small heads-up that I should have mentioned early in this thread. If you want to mix different color nail polishes to make the best possible color match, DO NOT use plastic bottles/containers! The nail polish will usually eat right through the plastic. It might not be right away either. You might find a nasty mess a few days later. Use glass bottles.
Didn't Diane warn you? :lol:
Yes, she did! But I already knew better from all the chemistry I had in college! :P :mrgreen:

Re: Repairing A Chip

Posted: Sat Jan 02, 2010 2:37 pm
by BobKat
Once I used nail polish remover to clean some stray brish strokes of silver off of a model car on which I was painting in the chrome and stainless trim on the sides. Imagine my surprise a few days later when the model literally disintegrated at the slightest touch. :-(

Re: Repairing A Chip

Posted: Mon Jan 04, 2010 2:31 am
by rickenbrother
Bob, I hope it wasn't a favorite that you had done alot of work on!