Rickresource Rickenbacker Forum

Posted: **Sat May 06, 2006 12:16 pm**

Eh... Stephen King, that is (one of my favorite writers, BTW... but i'd prefer it written, not done)

Posted: **Sat May 06, 2006 12:40 pm**

"This Old Gretsch" I'd much rather see "This Old RIC". Paul and Dale would be the congenial hosts and Pamela Lee (or whatever her name is today) would be the hostess (with the mostess). Whaddya think?

Posted: **Sun May 07, 2006 5:41 am**

Paul, this model Gretsch ('64 Tennessean) originally had painted on f-holes!
At some point in its sad past some axe murderer decided to transform them into real f-holes. Perhaps some binding could be added to clean it up? I'll have to look into it.

Posted: **Sun May 07, 2006 7:00 am**

David, Look no further. If anything could be done to fix it, you're in the right place, right thread.

Posted: **Sun May 07, 2006 2:56 pm**

David, see my post on runaway Dremel Tool...should have added 6119 to 6122, etc...

Posted: **Tue May 09, 2006 6:25 am**

Paul - Very early in this thread you mentioned a 1/8" pilot shank bit. Where did you get it?

Posted: **Tue May 09, 2006 6:46 am**

Larry--I made it, after looking for one hither and yon.

Posted: **Tue May 09, 2006 11:09 pm**

Darn.

Posted: **Wed May 10, 2006 6:11 am**

Any possibility of sharing a shot of it?

Posted: **Fri May 19, 2006 7:49 am**

Paul, How is that 350V63MG coming along with the F-Hole? I'm curious to see.

Posted: **Fri May 19, 2006 11:04 am**

Next week, hopefully.

Rickresource Rickenbacker Forum

Adding an F-hole and binding