Secondary impedence of M-16

dansamp · Post by **dansamp** » Fri Nov 24, 2006 7:22 pm

I am working on a friends M-16 could someone tell me what the impedence of the OT is
the amp did not have speakers and I installed some Eminence Alnico Blues out of early Reissue Bassman
is it 4 ohms or 8 ohms ???

Dan..........

tracy · Post by **tracy** » Sat Nov 25, 2006 11:16 am

2 ohms! Four 8 ohm 10" speakers wired in parallel, just like a 4/10 Bassman. BTW -- I still have a few of those transformers N.O.S. buried away in my storage somewhere.

dansamp · Post by **dansamp** » Sat Nov 25, 2006 2:21 pm

ok,thanks
by the way is there a pic or layout of how the tone controls should be wired??
someone had previously changed the tone circuit, the treble pot was a dual ganged 500k and there were no capacitors in the circuit
I have wired (I think) like the schematic but there doesn't seem to be much of an affect when turning the pots
I have read this is a very nice tone circuit so I must have something wrong .
any ideas ???

Dan..........