4002 brdige and tailpiece . same as a 4001?

brycycle · Post by **brycycle** » Mon Dec 04, 2006 2:42 pm

i found a guy selling a 4002 bridge,which he took off the bass when he bought it to replace with a badass (no, he no longer has the 4002).

i could use a new (to me) bridge on one of my 4001. are they identical?

wints · Post by **wints** » Mon Dec 04, 2006 2:43 pm

Yes, I believe they are...

dswp · Post by **dswp** » Mon Dec 04, 2006 2:58 pm

I think so too...

rickfan60 · Post by **rickfan60** » Mon Dec 04, 2006 3:56 pm

It is exactly the same part.

brycycle · Post by **brycycle** » Mon Dec 04, 2006 4:09 pm

three yes'. i'll take that as yes.

jwr2 · Post by **jwr2** » Mon Dec 04, 2006 5:41 pm

yep the 4000, 4001, 4002, 4003, 3000, and 3001 all have the same tailpiece/bridge assembly ... with a few small variations through the years ...

johnallg · Post by **johnallg** » Mon Dec 04, 2006 7:27 pm

I'd say those 4 should have a prety good idea about the tailpieces!

doctorwho · Post by **doctorwho** » Tue Dec 05, 2006 2:39 pm

I don't have a picture of the 'brdige' (Icelandic? Swedish?

), but here's one of the bridge/tailpiece:

brycycle · Post by **brycycle** » Tue Dec 05, 2006 3:26 pm

Icelandic? Swedish? no - Estonian. just kidding.

he sold it "just before" i tried to contact him. too bad, as he removed it as soon as he bought the bass, so there would not have been any 'lift'.