Vintage 325/350 case

shackleton · Post by **shackleton** » Wed Dec 13, 2006 4:17 pm

I will have an 80's case for sale soon. I won it and didnt think to make sure it fits a 360.

doctorwho · Post by **doctorwho** » Wed Dec 13, 2006 6:51 pm

Eric, when you post it for sale, be sure to include the measurement for the largest width in the body area. Some earlier '80s 320s are slightly wider than the later ones. I had a 1981 320 MG that barely fit in a 320 case I bought on eBay, and it would not fit in a 325v63 reissue case. I think that the c59 and v63 reissues will fit OK as they have slightly less wide bodies.

jingle_jangle · Post by **jingle_jangle** » Thu Dec 14, 2006 8:25 am

So, a 325 and 350 case are the same length?

nab · Post by **nab** » Thu Dec 14, 2006 10:11 am

The case for my 1996 is slightly shorter than my 350's. About 2 inches measuring the outside

jingle_jangle · Post by **jingle_jangle** » Thu Dec 14, 2006 11:14 am

Thanks, Jack. I thought that might be the case. And 2" is more than "slightly"!

Eric, you should measure the length of that case and see which guitar it truly fits. It'll save some grief...

shackleton · Post by **shackleton** » Thu Dec 14, 2006 11:45 am

I should get it today. I will not be keeping it because I bought it for my 360. Dummy. I will measure and make sure I post what it fits.

shackleton · Post by **shackleton** » Thu Dec 14, 2006 6:04 pm

have a case for sale. Very good condition. Inside and out. No tears, scuffs or scratches. I even still has the plastic on the Ric name plate. I was told this was made in the 80's. The only flaw is the hard ware has slightly tarnished. Adds to a vintage look if you as me. Inside dimensions are 12 3/4 x 38 1/2. I am in Califonia. Email for a pic.