Refretting a 4001

Setup, repair and restoration of Rickenbacker Instruments

Moderator: jingle_jangle

Post Reply
User avatar
jingle_jangle
RRF Moderator
Posts: 22679
Joined: Wed Dec 22, 2004 6:00 am
Contact:
Contact jingle_jangle

Post by jingle_jangle »

Scale length is the same, I assume? Did you remove and re-install the truss rods?
“I say in speeches that a plausible mission of artists is to make people appreciate being alive at least a little bit. I am then asked if I know of any artists who pulled that off. I reply, 'The Beatles did.”
― Kurt Vonnegut
Top
325_fan
Member
Posts: 368
Joined: Thu Sep 16, 2004 6:24 am

Post by 325_fan »

I only changed out the fingerboard. I left the truss rods right in there.
Top
Post Reply

Return to “"Vibrola" Rickenbacker Technical Forum: By Paul Wilczynski”