Shoeless CS ??!!

gray · Post by **gray** » Wed Feb 21, 2007 2:49 pm

I can only imagine that people are waiting to make a better move later. Horsehoes can be found. I'd be bidding on it if I could spend the cash.

johnallg · Post by **johnallg** » Wed Feb 21, 2007 3:33 pm

I would believe the reserve is very near or at the Buy It Now. This is a really decent price considering what they have been going for. Wish I could justify that amount.....

law · Post by **law** » Thu Feb 22, 2007 8:42 am

Up to $1875. That's a little more like it. Shame. I was hoping I could get a CS for under a grand. HAHAHAHa. Yeah right.

rickfan60 · Post by **rickfan60** » Thu Feb 22, 2007 9:05 am

RIC uses some unusual screws on the treble pickup surrounds of the 4003. The same screws are used on the jackplates, tuners, and TRC. They have thick heads but are just a little bigger across than the tip of the screwdriver - apparently not a common head shape for such a small screw. My V63 has them and I have found I can actually rest my thumb on the screw head at the rear of the surround. I have considered putting a screw like that on my '63.

I have searched screw catalogs and cannot find anything similar to what RIC uses so I make my own by griding down the head diameter of a stainless screw that has the same length and thread type.

squirebass · Post by **squirebass** » Thu Feb 22, 2007 9:15 am

I love the horseshoes on my v63s and I even put a cover on my 4001 so I could play it the same way. But I use a pick a lot and over the years I've gotten very used to playing that way so it doesn't get in my way at all...

rickaddict · Post by **rickaddict** » Thu Feb 22, 2007 9:44 am

I've got an extra RIC treble surround/tuner/TRC/jack screw I can give you next time I see you Ted.

We need to get together soon anyway.

johnhall · Post by **johnhall** » Thu Feb 22, 2007 10:07 am

RIC uses some unusual screws on the treble pickup surrounds of the 4003.

It's a basic, off-the-shelf fillister head screw.

johnallg · Post by **johnallg** » Thu Feb 22, 2007 1:48 pm

Ted:
4003 Screw

rickfan60 · Post by **rickfan60** » Thu Feb 22, 2007 2:07 pm

I have checked out several fillister and cheese head screws but none are the same as the RIC screws. I talked to Paul W. about it and he could not find them either. I have not tried Zero Products before but I will now.